Eagle Electronics AccuMap 12 - Manual (Page 26)

22
Save Current Plot Trail
You can save up to two plot trails in memory.
The receiver saves these trails even if power
is removed from the unit.
To save your current plot trail, highlight the
“Save Current Plot Trail” menu using the arrow
keys. Now press the right arrow key. The screen
at right appears.
You can save the plot trail as #1 or #2. Highlight the desired plot trail
number, then press the right arrow key. A message box appears asking
you if you really want to save the trail. Follow the instructions in this box.
The mapping screen appears after the message box clears. Your plot trail
is now stored in memory.
To view your saved plot trail, see the “Set Visible Plot Trails” section.
Set Plotter Update Criteria
The plotter places a dot on your trail as you
move. It determines when to place a dot de-
pending on two things: time and distance. By
default, it places a dot every three seconds.
To change the update, highlight the “Set Plot-
ter Update Criteria” menu item, then press the
right arrow key. The screen at right appears.
To change the update to distance, press the
right arrow key while the “Plot Update Criteria” menu is highlighted.
Change the plotter update time by highlighting the “Plot Update Rate”
menu, then press the left or right arrow keys until the desired time ap-
pears.
The distance update is changed in the same manner. Highlight the “Up-
date Distance” menu, then press the left or right arrow keys until the de-
sired distance appears.
When you have everything on this menu adjusted to the desired settings,
press the EXIT key to erase the menu.