Barco F80-4K9 9000-Lumen 4K UHD DLP Laser Projector (No Lens) - Manual (Page 151)

151 R5906852 /09 F80
• Laser on time
• Laser shut time
• System uptime
How to display the statistics
1. In the main menu, navigate to Settings → Maintenance → Advanced , while you are logged in.
Image 11–11 Maintenance menu, Advanced
2. In the Advanced Settings menu, select Statistics .
Image 11–12 Advanced settings, Statistics
The Statistics menu will be displayed.
Image 11–13
3. Use the left and right keys to shift between Fan statistics , System statistics and Light source statistics .
11.5 Advanced Settings – Pixel Shift
About Pixel Shift
The 4k projector variants use an actuator to achieve a 4k resolution. This actuator can be calibrated by using
the XPR test pattern and subsequently adjusting parameters in the
Pixel shift menu until the desired result is
achieved. These settings are the following:
• Gain : The amplitude of the waveform, sent to the actuator. Default value: 0.65
• Resonance : The frequency of the actuator. When this value is 0, the actuator is off. High frequencies
mean much noise. Default value: 227 Hz
Advanced Settings