Barco F80-4K9 9000-Lumen 4K UHD DLP Laser Projector (No Lens) - Manual (Page 126)

R5906852 /09 F80 126
What should be set up for an Ethernet address?
Two ways can be used to assign an address:
• use the Automatic setting so that an automatic address will be assigned.
• Assign manually an IP address, Net-mask (subnet-mask), (default) gateway address.
-
Set the IP-Address field to the desired value. This must NOT be 0.0.0.0 for static IP-Address
assignment. The IP address identifies a projector's location on the network in the same way a street
address identifies a house on a city block. Just as a street address must identify a unique residence, an
IP address must be globally unique and have a uniform format.
- Set the Subnet-Mask as appropriate for the local subnet.
- Set the Default-Gateway to the IP-Address of the local router (MUST be on the local subnet!) on the
same network as this projector that is used to forward traffic to destinations beyond the local network.
This must not be 0.0.0.0. If there is no router on the projector's local subnet then just set this field to any
IP-Address on the subnet.
10.3.2 Wired IP address set up
How to automatically set up the IP address
1. In the main menu, select Settings → Communication → LAN .
Image 10–9 Communication menu, LAN
The LAN menu is displayed.
Image 10–10 Example of the LAN menu
2. To enable Automatic, make sure the Automatic slider is set to the right. The color of the slider will be blue.
An IP address will be automatically assigned if it can make a connection to the network..
When connected, it is indicated with the connection symbol and the indication Connected .
3. Select APPLY and confirm.
How to manually set up the IP address
1. In the main menu, select Settings → Communication → LAN .
GUI – System Settings