Barco F80-4K9 9000-Lumen 4K UHD DLP Laser Projector (No Lens) - Manual (Page 123)

123 R5906852 /09 F80
How to change
1. In the main menu, select Settings → Communication → IR control .
Image 10–3 Communication menu, Remote Control
The Remote control menu is displayed.
Image 10–4 Example of the Remote control menu
2. Select the current projector address and enter a new address.
3. Select APPLY and click OK to apply the changes.
From now on the projector will only listen to this new address and to its broadcast address.
10.1.3 IR sensors
What can be done?
Each IR sensor can be individually disabled or enabled.
When all sensors are turned off, the projector will no longer respond to signals from the remote control. To re-
enable the sensors, use the menu keypad on the projector.
How to disable
1. In the main menu, select Settings → Communication → IR Control .
Image 10–5 Communication menu, Remote Control
The IR control menu is displayed.
GUI – System Settings