Configuring netbios name filtering – EXP Computer PathBuilder S200 User Manual
Page 82
78
Bridging
Bridge Filtering
Configuring NetBIOS Name Filtering
Introduction
This section describes how to use the Control Terminal Port (CTP) to configure
NetBIOS Name Filtering.
How to Configure
NetBIOS Name
Filtering
Follow these steps:
Bridge Link
Parameters Record
Figure 40 highlights the parameter, NetBIOS Name Filter Action, in the Bridge Link
Parameters record.
Figure 40. Bridge Link Parameters Record
Step
Action
1
Configure the NetBIOS Name Filter Action parameter in the Bridge Link
Parameters.
2
Configure the parameters in the NetBIOS Name Filter Table record.
Entry Number
Hop Count Limit
Largest Frame Size
MAC Address Filter Action
Protocol Filter Action
NetBIOS Name Filter Action
STPE Link State
Node:
Address:
Date:
Time:
Menu: Configure Bridge
Path
Bridge Parameters
Bridge Link Parameters