EXP Computer PathBuilder S200 - Manual (Page 110)

106 Bridging
LLC2 Local Termination
Configuring Local Termination
Configuring for
Local Termination Perform the following procedures to configure Local Termination on a Bridge node.
Before You Begin Connect to the node using Control Terminal Port (CTP) access.
Obtain the following information:
• MAC Address of the device being spoofed.
• SAP value of the device being spoofed.
Configuring the
Bridge Follow these steps to configure bridge parameters to enable Local Termination on a
node.
Step Action
1 Configure the node.
2 Configure the ports.
3 Configure the route selection table.
4 Configure the LAN connection table.
5 Configure the Mnemonic Table and PVC Setup table.
6 Configure the bridge for Local Termination.
Go to ““Configuring the Bridge” section on page 106”, for details on
configuring the bridge table for Local Termination.
Step Action Result
1 Select Configure -> Configure
Bridge from the Main menu.
Note
Bridge must be configured for
source routing.
(*Bridge Type=SR).
The Configure Bridge Record
menu appears.