EXP Computer PathBuilder S200 - Manual (Page 25)

Bridging 21
T0008-16F Release 5.2M
Configuring the PathBuilder S200 Series Switch for Bridging Operation
Configuring the PathBuilder S200 Series Switch for Bridging
Operation
Introduction This section shows you how to configure a PathBuilder S200 series switch for
bridging operation.
What You Need to
Configure When you are performing a Transparent Bridging operation, configure the following
records in the bridge node:
• Node Record
• LAN Port Record
• Bridge Record
• Bridge Link Record
• LAN Connection Table
• Optional Filter Tables
• LAN Server Subsystem (LSS) Record (optional)
• Autocall Mnemonic Table (Some of the WAN Adapter connections are
configured to Autocall.)
• Routing Table (At the destination node, a LAN Connection [LCON] entry is
needed for the WAN Adapter.)
For general details on configuring the Node record and the LAN Port record, refer to
the PathBuilder S200 Series Basics Protocols. For details on LAN Server Subsystem
configuration, see the “LAN Server Subsystem” section on page 120.
The following sections describe how to configure the records and tables critical for
performing bridging on a PathBuilder S200 series switch.