Enterasys Networks 7S4280-19-SYS User Manual
Page 59
Completing the Installation
Enterasys NAC Controller Hardware Installation Guide 4-19
First-Time Log-In Using a Console Port Connection
Start the Command Line Interface (CLI) from the module’s local console port as follows:
1.
Connect a terminal to the local console port as described in “
” on page 4‐14. The startup screen,
, displays.
2.
At the login prompt, enter one of the following default user names:
–
ro for Read‐Only access,
–
rw for Read‐Write access, or
–
admin for Super User access. (This access level allows Read‐Write access to all modifiable
parameters, including user accounts.)
3.
Press ENTER.
4.
The Password prompt displays. Leave this string blank and press ENTER. The module
information and Matrix prompt displays as shown in
.
The chassis is now ready to be configured. For information about setting the IP address and
configuring Telnet settings for remote access to NAC Controller PEP management, refer to
Chapter 3 in the Enterasys Matrix DFE‐Diamond/Platinum Series Configuration Guide. The CLI
commands enable you to initially set up and perform more involved management configurations.
The Enterasys Matrix DFE‐Diamond/Platinum Series Configuration Guide is available online at:
If you require assistance, contact Enterasys Networks using one of the methods described in
“
.
Note: This procedure applies only to initial log-in, and to logging in to a device not yet configured
with administratively-supplied user and password settings.
By default, the Matrix NAC Controller PEP Series device is configured with three user login
accounts: ro for Read-Only access; rw for Read-Write access; and admin for super-user access to
all modifiable parameters. The default password is set to blank (carriage return). For information on
changing these default passwords, refer to Chapter 3 in the
Enterasys Matrix
DFE-Diamond/Platinum Series Configuration Guide
.