Enterasys Networks 7S4280-19-SYS - Manual (Page 24)

Overview
1-4 Introduction
The 2S4082-25 NAC Controller PEP
The 2S4082‐25 NAC Controller PEP has 24, 10BASE‐T/100BASE‐TX/1000BASE‐T compliant ports
by means of 24 fixed front‐panel RJ45 connectors on the PEP and 2, Mini‐GBIC Gigabit ports.
The 2S4082‐25 is installed in the Enterasys Matrix N1 chassis.
Figure 1-1 2S4082-25 NAC Controller PEP
1 OFFLINE/RESET switch 7 GROUP SELECT LEDs 13 VGA port
2 RJ45 COM (Console port) 8 Mini-GBIC Gigabit port slots (2) 14 RS232 serial COM port
3 CPU LED 9 Gigabit port link/activity LEDs 15 CPU power LED
4 MGMT LED 10 USB port 16 CPU reset button
5 GROUP SELECT button 11 10/100 Ethernet port link LED 17 Hard drive activity LED
6 GROUP STATUS LEDs 12 10/100 Ethernet port (see Note below) 18 10/100 Ethernet port activity LED
19 Ports (1-24), 10/100/1000 Mbps, via 24
RJ45s
Note: The 10/100 Ethernet port is for management purposes only. If you want network
connectivity, you need to connect to one of the ports with 10/100/1000 Mbps ports as
shown in
Figure 1-1 .