Ashly FX60.2 Multipurpose Installation Network Amplifier with DSP (1 RU, 1/2 Rack) User Manual
Page 5

5
FX Amplifier • Operating Manual
FX IP connected power amplifiers have been
designed to provide configurable, consistent
and reliable high performance audio power
amplification for residential, commercial
and entertainment applications. Please
read this manual fully before installing and
using an amplifier. If you have any questions
regarding amplifier configuration, installation
or operation please contact the appropriate
customer support portal.
Table of Contents
1 -
Amplifier Overview
2 - Carton Contents
3 - Installation
4 - AC Mains and Network Configuration
5 - Configuration Menus
6 - Setup and Signal Routing
7 - GPIO Setup and Connections
8 - Input and Speaker Connections
9 - Operation
10 - Signal Flow and Panel Diagrams
11 - Specifications
12 - Rear Panel Drawings
13 - Warranty
1. Introduction and Overview
1.1a Full-Rack, FX500 Models
FX 500.4, FX 500.2
FX500 amplifiers can drive conventional low
impedance speakers (Low-Z mode, 2Ω to 16Ω).
They can also drive 25V transformer coupled
speakers using the Low-Z output. In Hi-Z mode,
the amp can drive 70V or 100V high impedance
transformer coupled loudspeakers. Each model
provides four analog inputs, stereo S/PDIF
digital input & output, and either two or four
outputs (Low-Z mode), or one or two output (Hi-
Z or Lo-Z *BTL mode).
Model &
Mode
Channels
Max Rated
Output/Ch
FX 500.4
Lo-Z
Four
500W
*Lo-Z (BTL)
Two
1000W
Hi-Z
Two
1000W
FX 500.2
Lo-Z
Two
500W
*Lo-Z (BTL)
One
1000W
Hi-Z
One
1000W
*Note: In Lo-Z BTL mode (bridge-tied load),
two amplifier output channels are combined to
create a single, double power output channel.
BTL mode can be engaged via the amplifier
Output Mode configuration setup menu
of this manual.
1.1b Half-Rack, FX125/60 Models
FX 125.4, FX 125.2, FX 60.4, FX 60.2
FX125 and FX60 amplifiers can drive
conventional low impedance speakers (Low-Z
mode, 4Ω to 16Ω). They can also drive 25V
transformer coupled speakers using the Low-Z
output. In Hi-Z mode, the amp can drive 70V or
100V speakers. Each model provides four analog
inputs, stereo S/PDIF digital input & output, and
either two or four outputs (Low-Z mode), or one
or two output (Hi-Z or Lo-Z *BTL mode).
FX125 and FX60 models incorporate automatic
power sharing technology that enables power
to be shared proportionately as required
between the two outputs when in Low-Z mode.
Model &
Mode
Channels
Max Rated
Output/Ch
FX 125.4
Lo-Z
Four
125W
*Lo-Z (BTL)
Two
250W
Hi-Z
Two
250W
FX 125.2
Lo-Z
Two
125W
*Lo-Z (BTL)
One
250W
Hi-Z
One
250W
FX 60.4
Lo-Z
Four
60W
*Lo-Z (BTL)
Two
120W
Hi-Z
Two
120W
FX 60.2
Lo-Z
Two
60W
*Lo-Z (BTL)
One
120W
Hi-Z
One
120W
Overview