Ashly FX60.2 Multipurpose Installation Network Amplifier with DSP (1 RU, 1/2 Rack) - Manual (Page 20)

20
FX Amplifier • Operating Manual 11. Amplifier Specifications, FX500 Models
Model FX 500.2 FX 500.4
Output Channels 2 Low-Z or 1 Hi-Z 4 Low-Z or 2 Hi-Z
Output power @ 2Ω 2 x 500W (SE)* 4 x 500W (SE)
Output power @ 4Ω
2 x 500W (SE)
1 x 1000W (BTL)**
4 x 500W (SE)
2 x 1000W (BTL)
Output power @ 8Ω
2 x 250W (SE)
1 x 500W (BTL)
4 x 250W (SE)
2 x 500W (BTL)
Output power @ 25V † 2 x 320W (SE) † 4 x 320W (SE) †
Output Power @ 70V 1 x 1000W (BTL) 2 x 1000W (BTL)
Output Power @ 100V 1 x 1000W (BTL) 2 x 1000W (BTL)
Total System Power 1000W 2000W
Power Consumption 550W 1100W
Thermal Output (BTU/hr,
1/8th Full Power, 2Ω Load)
225 436
Output Voltage
65Vp/130Vpp
(SE unloaded)
130Vp/260Vpp
(BTL unloaded)
65Vp/130Vpp
(SE unloaded)
130Vp/260Vpp
(BTL unloaded)
Weight 5.9 kg (13 lbs) 7.4 kg (16.3 lbs)
Dimensions 88 x 440 x 332 mm (3.5 x 17.3 x 13.1 in)
Output Circuitry Class D - full bandwidth PWM modulator with ultra-low distortion
Output Voltage 70 Vp / 140 Vpp (unloaded) / Bridged 140 Vp / 280 Vpp (unloaded)
Signal To Noise-Ratio > 108 dB (A-weighted 20 Hz - 20 kHz 8 Ω load)
THD+N (typical) < 0.05 % (20 Hz - 20 kHz 8 Ω load 3dB below rated power)
Frequency Response 20 Hz - 20 kHz (+0/-0.5 dB (8 Ω load 3dB below rated power)
Protection Circuits Short Circuit, Output DC, Undervoltage, Temperature, Overload protection
Power Supply Universal mains switch mode power supply with Power Factor Correction (PFC) and integral standby converter
Operating Voltage Universal Mains, 100-240V, 50Hz-60Hz
Standby Consumption < 0.5W
Accessories 2x rack ears, 4x adhesive feet (included), WR-1 & WR-1.1 GPIO Remote Volume Control (sold separately)
Power Ratings 1% THD @ 120VAC and 230VAC
*SE - conventional, Single Ended output mode. **BTL - Bridge-Tied Load output mode.
† For 25V output, set DSP output limiter threshold at 25V using RMS voltage setting.