Ashly FX60.2 Multipurpose Installation Network Amplifier with DSP (1 RU, 1/2 Rack) - Manual (Page 22)

22
FX Amplifier • Operating Manual
Settings Menu
System Information Installation site info
Device Device info, device locator, firmware update
Backup & Restore Backup/restore device settings, restart device, factory reset
Speaker Library Create/Edit/Import speaker libraries
Power Management Set Auto-On options, change Standby timer, change Mute timer
GPIO Connector Pin assignment options
Pin 1 Ground only, for 12V trigger and standby/mute input reference
Pin 2 Off, Input for Standby (NO), Standby (NC), Mute (NO), or Mute (NC)
Pin 3 Ground only, for Voltage Control and Trigger Out reference
Pin 4 Off, Remote Volume Control
Pin 5 Off, Remote Volume Control
Pin 6 Off, Volume Control, 12V Trigger Input (12V trigger input requires Trigger-Mode selected in Power Management section)
Pin 7 Off, Remote Volume Control, 12V Trigger Out
Pin 8 3.3V only (used for remote GPIO volume control)
LAN Set LAN network mode to DHCP or Static IP. The wired LAN default static IP address is 192.168.64.100
WiFi WiFi ON/OFF, Disable WiFi on LAN connection, WiFi Disable timer, set WiFi mode to Access Point (hot spot) or Client.
The FX amplifier's WiFi access point (hotspot) IP address is 192.168.4.1, default password is "password"
Configuration Specifications (continued)
FX500 models
FX60 & 125 models