Ashly pne-c2 - Manual

Ashly PE Amplifier
PNE-C2 Cobranet Module
Field Installation
1) Remove the four screws
from the standard input as shown.
2) Carefully pull out the installed
standard input assembly, only as
far as shown. Note the ribbon
cable shown furthest left that is
labelled "ST992". Gently remove
this and the other two ribbon cables.
3) The PNE-C2 plugs are in the
same general location as the three
standard input plugs. Plug in the
cable "ST992" first. Be sure to fully
seat each connector, applying
even pressure across the top.
Do not stress the wires.
4) Gently guide the PNE-C2 module
back into the amplifier, and fasten
the four mounting screws.
Remove Four Mounting Screws
aiHPf ^ ^ ^
. - •• • " J
T i T i i t r v » - /
i * I P i
www.ashly.com