Ashly FX60.2 Multipurpose Installation Network Amplifier with DSP (1 RU, 1/2 Rack) - Manual (Page 19)

19
FX Amplifier • Operating Manual 11. Amplifier Specifications, FX60 & FX125 Models
Model FX 60.2 FX 125.2 FX 60.4 FX 125.4
Outputs 2 Low-Z or 1 Hi-Z 2 Low-Z or 1 Hi-Z 4 Low-Z or 2 Hi-Z 4 Low-Z or 2 Hi-Z
Output power @
4Ω/8Ω/25V † /70V/100V*
All channels driven
60W Low-Z
120W Hi-Z
125W Low-Z
250W Hi-Z
60W Low-Z
120W Hi-Z 125W Low-Z
250W Hi-Z
Output power @
4Ω/8Ω/25V † /70V/100V*
Single channel driven
120W** 250W** (156W) † 250W** 250W** (156W) †
Output power @ 16Ω***
Single channel driven
120W 125W 125W 125W
Power Consumption 75W 75W 75W 150W
Thermal Output (BTU/hr,
1/8th Full Power, 4Ω Load)
61 78 98 152
Dimensions
44 x 220 x 213 mm
(1.7 x 8.7 x 8.4 in)
44 x 220 x 213 mm
(1.7 x 8.7 x 8.4 in)
44 x 220 x 319 mm
(1.7 x 8.7 x 12.6 in)
44 x 220 x 319 mm
(1.7 x 8.7 x 12.6 in)
Weight 2.0 kg (4.4 lbs) 2.0 kg (4.4 lbs) 2.8 kg (6.2 lbs) 2.8 kg (6.2 lbs)
Output Circuitry Class D - full bandwidth PWM modulator with ultra-low distortion
Output Voltage 70 Vp / 140 Vpp (unloaded) / Bridged 140 Vp / 280 Vpp (unloaded)
Signal To Noise-Ratio > 106 dB (A-weighted 20 Hz - 20 kHz 8 Ω load)
THD+N (typical) < 0.05 % (20 Hz - 20 kHz 8 Ω load 12.5% rated power)
Frequency Response 20 Hz - 20 kHz (+0/-0.25 dB (8 Ω load 12.5% rated power)
Protection Circuits Short circuit protection. DC protection. under voltage protection. temperature protection. overload protection
Power Supply Universal mains switch mode power supply with Power Factor Correction (PFC) and integral standby converter
Operating Voltage/
Frequency
Universal Mains 100-240V 50-60Hz
Standby Consumption < 0.5W
Accessories (sold separately)
FA1.2RM rack ear, half-rack extension, connection plate; FA2.2RM rear-support kit; FATWB desk/wall mount
kit, WR-1 & WR-1.1 GPIO Remote Volume Control
Power Ratings 1% THD @ 120VAC and 230VAC
* 100V line mode operates at 90V (≈-1dB)
** Power sharing operational (FX60 and FX125 models only)
*** 16 Ohm power output is limited by the maximum voltage swing available in low impedance mode
† For 25V applications,maximum power with power sharing is 156W. Output load must be >4 Ω