21 system settings, 1 language setting, 2 system time and date – ARRI ALEXA Mini LF Ready to Shoot V-Mount Set (LPL) User Manual
Page 97: 3 button and display settings, 4 fan settings, 5 battery warning, System settings, Language setting, System time and date, Button and display settings
System Settings
97
21 System Settings
21.1 Language Setting
1. Select
MENU > System > Language
.
2. Set the language to either English or Chinese (simplified).
21.2 System Time and Date
► Select
MENU > System > System Time + Date
to set the system time and date.
Note:
Timezone
and
Daylight Saving Time
do not change time and date settings. They are stored
as metadata in the recorded clips.
Note: System Time and Date are reset after a camera software update.
21.3 Button and Display Settings
► Select
MENU > System > Buttons + Display
.
Following options are available:
Display Style
Button Brightness
Choose between day mode and night mode.
Adjust the brightness of camera and MVF buttons from 0 to 4 (0 = off)
21.4 Fan Settings
Select to set the fan mode to
Low Noise
for locations with ambient temperatures up to 30°C (86°F).
For locations with ambient temperatures higher than 30°C (86°F), set to
Rec Low
. When the fan is set
to Rec Low, it will run at a high rate when the camera is in Standby, and run at a low rate when the
camera is recording.
► Select
MENU > System > Fan Mode
.
Following options are available:
Rec Low
Increases fan speed during standby to cool the camera. Minimizes fan
speed/noise during recording.
Note: Ideal in an environment warmer than 30 °C (86 °F).
Low Noise
Minimizes fan noise during standby and recording.
Note: With data rates above 100 MB/s (due to fps/codec setting), the fan
speed automatically increases to prevent the recording media from over-
heating.
21.5 Battery Warning
You can adjust the voltage level at which a power warning is displayed for the power source connected
to the BAT connector. The level can be adjusted to match the battery type used. The default warning
value is 13.5 V.
► Select
MENU > System > Power > BAT In Warning
and set the warning level between 11.0 V and
34.0 V.
When the power source reaches the defined voltage level the battery display on the HOME screen
and in the status info of the viewfinder and SDI outputs start flashing.