ARRI ALEXA Mini LF Ready to Shoot V-Mount Set (LPL) - Manual (Page 11)

For Your Safety / 为了您的安全 11
Specific Safety Guidelines
► Do not remove any safety measures from the system.
► Do not operate the system in areas with humidity above operating levels or expose it to water or
moisture.
► Do not subject the system to severe shocks.
► Do not cover the camera fan openings.
► During extended operation, high data rates and/or operation at high ambient temperatures, the
camera's surfaces and especially the area around the fan outlet can get hot. Use caution and never
cover, obstruct or block the fan inlet or outlet while the camera is powered.
► Direct sunlight can result in camera housing temperatures above 60 °C (140 °F). At ambient
temperatures above 25 °C (77 °F), protect the camera from direct sunlight.
► Do not point the camera sensor into direct sunlight, very bright light sources or high energy light
sources (e.g. laser beams). This may cause permanent damage to the camera image sensor.
► Do not place the system on an unstable trolley/hand truck, stand, tripod, bracket, table or any other
unstable support device. The system may fall, causing serious personal injury and damage to the
system or other objects.
► Never insert objects of any kind into any part of the system if not clearly qualified for the task in the
manual, as objects may touch dangerous voltage points or short out parts. This could cause fire or
electrical shock.
► Do not remove any stickers or paint marked screws.
► When no lens is attached to the camera, immediately place the protective cap on the lens mount to
avoid contamination of the sensor cover glass.
► If the sensor cover glass has been contaminated by solid dirt or grease, special optical cleaning kits
should be used for dirt removal under very high care. If the contamination cannot be removed, the
camera should be taken to an ARRI service center for cleaning.
► Clean optical lens surfaces only with a lens brush or a clean lens cloth. In cases of solid dirt or
grease, moisten a lens cloth with pure alcohol. Discard contaminated lens cloth after use. Never
attempt to clean a lens brush with your fingers.
► Do not use solvents for cleaning.
► Never use Acetone to clean optical surfaces.
► The use of Methanol to clean optical surfaces is not recommended.
► Never use cans with compressed air to blow off dust. This can severely damage optical elements.