FlashForge Adventurer 3 Pro 2 3D Printer - Manual (Page 44)

2.5.3 Filament
Load
The extruder is heated up to the target temperature.
After heating is completed, insert the filament into the filament intake until some
resistance is sensed (push the filament into the feeding wheel).
Loading is completed when there is filament coming out of the nozzle.
Change
The extruder is heated up to the target temperature. After heating is completed,
filament will be withdrawn from the extruder.
Pull out the filament according to the instructions.
Insert the new filament into the filament intake, and tap [OK] ;
The new filament will be fed into the extruder. Replacement is completed when
there is filament coming out of the nozzle.
Manual
Wait until the extruder is heated up to
the target temperature, choose the
loading length, and click on [Load];
Insert the filament into the filament
intake until some resistance is sensed.
Filament coming out of the nozzle
indicates a successful loading.
41
100 mm
300 mm
Load
200 mm
Load
Change
Manual
240
/240℃
Load
Change
Manual
Unloading the filament,
please wait...
240
/240℃
Pull out filament,
feed new filament, press [OK]
OK
240
/240℃
Please insert the filament
OK
240
/240℃
Load
Change
Heating extruder...
Cancel OK OK
Preheat completed.
Begin loading.
Press OK when new color appears
Manual
230
/240℃
240
/240℃
240
/240℃