FlashForge Adventurer 3 Pro 2 3D Printer - Manual (Page 32)

1. Tap [Filament] - [Change], and the extruder starts
preheating.
2. Open the filament cover.
3. Pull out the filament as
the picture below shows.
6. When the new filament is extruded steadily, filament
change is completed and tap [OK].
5. Put the spool of filament on
the spool holder, and close
the filament cover.
4. Insert the new filament into the filament intake
and push the filament into the feeding wheel
until resistance is sensed.
2.4.6 Filament Change
Load
Change
29
Pull out filament,
feed new filament, press [OK]
OK
240
/240℃
Please insert the filament
OK
240
/240℃
Heating extruder...
Cancel
230
/240℃