FlashForge Adventurer 3 Pro 2 3D Printer User Manual

Page 16

1. Click [Start] and the machine starts pre-calibration. The ﬁrst point is to calibrate the initial

distance between the nozzle and the platform. Click the Up and Down arrows to adjust

the Z-axis deviation value; Insert a leveling card between the nozzle and the platform.

If it cannot be inserted, it means that the nozzle and the platform are too close. Click the

Up arrow to make the nozzle away from the platform.

2. Insert and slide the leveling card. If there is no frictional resistance, click the Down

arrow to make the nozzle closer to the platform; When there is slight friction resistance,

it means that the distance is appropriate.

Auto Calibration

When the platform is uneven it is

recommended to turn on this

function and click the start

button below to make plane

compensation

Click the arrow to adjust the

nozzle so that it just touches

the platform

Start

Extruder