FlashForge Adventurer 3 Pro 2 3D Printer - Manual (Page 18)

15
Mind the loading direction of filament. Make sure it is clockwise as the
picture shows.
3. Tap [Filament]. 4. Tap [Load] and the extruder starts heating.
Build
Tools
Filament
Load
Change
Manual
Heating extruder...
Cancel
230
/240℃
2. Put the spool of filament on the spool holder and close the filament cover.
5. As shown on the right, loading starts when the extruder
is heated to the target temperature.
Note: The extruder will be heated to the highest
temperature by default during automatic filament feeding
and withdrawing. Actually, the extruder heating
temperature can be adjusted according to the used
filament when in practical use.
OK
Preheat completed.
Begin loading.
240
/240℃