Datavideo PTR-10 MK II Robotic Head & RMC-180 MK II Pan/Tilt Controller Kit - Manual (Page 13)

13
2.1 Installing your Camera
Follow the steps outlined below to install the camera:
1. First place the camera on the camera mount base.
2. Align the 1/4" screw hole found at the base of the camera with the 1/4" screw hole in the
camera mount base.
Note: If only a 3/8” threaded screw hole is found at the base of the camera, put a 3/8” to 1/4"
nut adapter in the hole then tighten with a coin or a flat head screwdriver.
3. Finally secure the camera with a 1/4" hand screw.
Camera Mount Base
1/4" Hand Screw