GeChic On-Lap 1102E 11.6" 16:9 Portable IPS Monitor - Manual (Page 20)

14
Chapter 5 Using Touch Monitor (Only for 1102I)
Section 1 Notices
1. Computer with operating system of Windows 10/7
supports On - Lap 1102I's touch function. If computer
does not be equipped with Windows 10/7, it may not
be able to use On - Lap 1102I's touch function. Please
be noticed whether the computer's operating system
supports an external touch monitor.
2. As the fig., USB power & touch cable ① can transmit both power and touch
signal at the same time; ② only can transmit power. If ① connector does
not connect to computer's USB port , then touch function will be no longer
available.
Section 2 Windows 10/7 Touchscreen Settings
If your computer does not enable touch screen function automatically or rec-
ognize multi - screen, then touch screen will not sense touch position accurate-
ly. Please use Windows 10/7 "Tablet PC Settings" of Control Panel to start
touch screen settings.
In Windows 10 , search "Calibration" at 'Settings', then select "Calibrate the
screen for pen or touch input." In Windows 7 , select "Tablet PC Settings" at
Control Panel to start touch settings.
As the fig. below, please select "Settings (S)", and follow Windows on - screen
instructions to calibrate the touch points on On - Lap 1102 to complete touch
settings.
Notice: Please check the USB - C port on your laptop/ smartphone supports HDMI video output
(USB Type C alt mode) before using the adapter.