GeChic On-Lap 1102E 11.6" 16:9 Portable IPS Monitor - Manual (Page 10)

P.S. If the monitor does not get enough power from a single USB port, it
may cause splash screen or display interruption. Please connect to two
USB ports on your PC or the 5V - 2A adapter.
4
As the fig. , connect On -
Lap 1102 to a laptop. On -
Lap 1102 can be powered
on through two USB ports
or a 5V
- 2A adapter. The
video input source is
"HDMI1".
Section 2 Installation of Vertical Display (Only for On - Lap 1102E/H)
As the fig. below, rotate aside the Cover Lock firstly, and take out the moni-
tor, then turn the monitor's back side to the Protective Cover . Do keep the
buttons on the topside.
○
1 Put the bottom half of the monitor into the Protec-
tive Cover, ○ 2 Put the top half of the monitor into the Indentation of the
Protective Cover. Rotate down the Clover Lock.
The min. viewing angle of vertical display
is 60 degrees. Do not attach the magnetic
buckle higher than the orange line , or it may
cause the monitor overturning.
As the fig. on next page, connect On - Lap 1102 to a laptop. On - Lap 1102 can
be powered on through two USB ports on your PC or a 5V2A adapter.