Features – Sony HDVF-EL30 0.7" FHD OLED Viewfinder with 3.5" Display for 4K/HD Cameras User Manual
Page 7
7
Features
Compact CMOS video camera
The SRG-XP1 is a video camera for indoor use
equipped with a 1/1.8-type CMOS sensor and
wide angle lens (102 degrees horizontal), while
the SRG-XB25 camera is equipped with a 1/2.5-
type CMOS sensor and an optical zoom lens
*1
.
This versatile camera can be used for various
applications.
Zoom performance
The SRG-XB25 is equipped with a 25x optical
zoom lens. Used together with up to 3x
*1
pixel
zoom and 2x digital zoom, it achieves the
equivalent of up to 150x telephoto performance.
The SRG-XP1 is not equipped with an optical
zoom lens, but features the same pixel zoom and
digital zoom to achieve the equivalent of up to 6x
telephoto performance.
Audio input/output
The camera is equipped with 2ch audio which is
applicable for microphone/line input.
The input audio signal is embedded in the HDMI
output for transmission. Additionally, the signal
can be transmitted over an IP network using the
streaming function.
The SRG-XB25 also supports 2ch line output.
Video output
In addition to HDMI and USB 3.0
*2
output, IP
network transmission can be performed
simultaneously using the streaming function.
For streaming function, ITU-T H.264/H.265 is
applied to video compression mode (video
codec) and it achieves high compression rate
while keeping the image quality. Also, it
decreases the network bandwidth load.
Moreover, the camera supports multi-streaming
output. Up to 3 codec modes can be selected.
Preset function
Up to 256 preset data can be stored using VISCA
commands and CGI commands.
The SRG-XB25 can store the zoom position,
whereas the SRG-XP1 can store the pan, tilt, and
zoom positions.
Equipped with RS-232 interface
(SRG-XB25 only)
The camera is equipped with RS-232 interface
which is the industry standard VISCA camera
protocol in external communication.
Equipped with PoE (Power over
Ethernet)
The camera supports IEEE802.3af-compatible
PoE (Power over Ethernet) and a single LAN cable
is used for power supply and control.
Compatible with VISCA over IP protocol
An IP connection can be established between
the camera and the remote controller.
Equipped with tally lamp
The camera is equipped with a tally lamp that
instantly distinguishes cameras in use.
Extensibility
NDI|HX
This camera is compatible with NDI|HX of
NewTek, Inc.
To use NDI|HX, you are required to purchase the
*1 Pixel zoom of up to 2x at 1080p resolution,
and up to 3x at 720p resolution is supported.
This does not function for other resolutions.
*2 Only the SRG-XP1 is equipped with a USB
output port.