Sony HDVF-EL30 0.7" FHD OLED Viewfinder with 3.5" Display for 4K/HD Cameras - Manual (Page 47)

47
[Time zone]
Set the time difference from Greenwich
Mean Time according to the area where the
camera is installed.
Select the time zone of the area where the
camera is installed from the drop-down list.
[Automatically adjust clock for daylight
saving time changes]
The clock time is automatically adjusted
according to the daylight saving time of the
selected time zone.
Note
If the time zone selected in [Time zone] is
different from that set on the computer, the
date and time applied the time zone
difference to are set on the camera.
[Installation] tab
Use this tab to perform settings related to
installation.
You can configure the settings from the OSD
menu. For details, see “SYSTEM Menu” (page 34)
or “VIDEO OUT Menu” (page 33).
[System]
[Image flip] (SYSTEM - IMG FLIP)
Flip an image vertically. Normally clear the
checkbox before use.
[IR receive] (SYSTEM - IR RECEIVE)
(SRG-XP1 only)
If you clear the checkbox, the camera does
not receive signals from the supplied remote
commander. Be sure to select the checkbox
when you use the supplied remote
commander.
[Tally level] (SYSTEM - TALLY LEVEL)
This is the setting related to the tally lamp.
[High]: Brightens the tally lamp.
[Low]: Darkens the tally lamp.
[Off]: Even when the tally-lamp-ON
command is issued, the tally lamp
does not light up.
[VISCA rate] (SYSTEM - VISCA BAUD RATE)
(SRG-XB25 only)
Sets the baud rate for VISCA communication.
Select [9600bps] or [38400bps].
LDC (SYSTEM - LDC) (SRG-XP1 only)
Sets the image distortion correction for the
lens at the Wide end.
[Video out]
Note
There are limitations on the combination of
[Resolution] and [Output source] settings.
For the supported combinations, see “Video
Output Specifications” (page 63).
[Resolution] (VIDEO OUT - VIDEO FORMAT)
Select the video output format of the signal
to be output from the HDMI output terminal.
[Output source]
[HDMI]:
HDMI image output.
[Stream]: Streaming image output.
[HDMI+Stream]: HDMI and streaming image
output.
[HDMI+UVC] (SRG-XP1 only): HDMI and USB
image output.
[Color space] (VIDEO OUT - COLOR SPACE)
You can set the color space of HDMI output.
[HDMI OSD menu]
Clearing the checkbox does not display the
OSD menu or message on the HDMI output
screen.
[Initialize] tab
Video output format
59.94 Hz system 3840×2160/59.94p
3840×2160/29.97p
1920×1080/59.94p
1920×1080/59.94i
1920×1080/29.97p
1280×720/59.94p
1280×720/29.97p
50 Hz system 3840×2160/50p
3840×2160/25p
1920×1080/50p
1920×1080/50i
1920×1080/25p
1280×720/50p