Sony HDVF-EL30 0.7" FHD OLED Viewfinder with 3.5" Display for 4K/HD Cameras - Manual (Page 53)

53
Configuring the
Network
— [Network] Menu
When you click in the Administrator
menu, the [Network] menu appears.
Use this menu to configure the network to
connect the camera and the computer.
The [Network] menu consists of the [Network]
and [UPnP] tabs.
[Network] tab
This section provides the menus for connecting
the camera through the network cable.
[Status]
[MAC address] (NETWORK - MAC
ADDRESS)
Displays the MAC address of the camera.
[Ethernet status]
Displays the current transmission rate.
[IP address] (NETWORK - IP ADDRESS)
Displays the current IP address.
[Subnet mask] (NETWORK - SUBNET
MASK)
Displays the current subnet mask.
[Default gateway] (NETWORK - GATEWAY)
Displays the current default gateway.
[Primary DNS server]
Displays the current primary DNS server.
[Secondary DNS server]
Displays the current secondary DNS server.
[IPv4 setting]
Configure the IPv4 network setting.
[Obtain an IP address automatically
(DHCP)]
Select [Obtain an IP address automatically
(DHCP)].
When the checkbox is checked, the IP
address, subnet mask, default gateway are
assigned automatically.
Note
When you check the checkbox, make sure
that a DHCP server is operating on the
network.
[IP address]
Enter the IP address of the camera.
[Subnet mask]
Enter the subnet mask value.
[Default gateway]
Enter the default gateway.
[Common setting]
Configure the IPv4 network setting.
[HTTP port number]
Enter the HTTP port number. Normally select
80.
[Obtain DNS server address automatically]
When the checkbox is checked, the
addresses of [Primary DNS server] and
[Secondary DNS server] are assigned
automatically.
Note
To obtain a DNS server address
automatically, first enable [Obtain DNS
server address automatically].
Ask the network administrator whether a
DNS server address can be obtained
automatically.
[Primary DNS server]
Enter the IP address of the primary DNS
server.
[Secondary DNS server]
Enter the IP address of the secondary DNS
server, if necessary.
[Camera name] (DEVICE INFO - NAME)
Name for the camera.
Up to 8 alphanumeric characters can be used
to set the name.
Network