Sony HDVF-EL30 0.7" FHD OLED Viewfinder with 3.5" Display for 4K/HD Cameras - Manual (Page 16)

16
Installation and Connection
Installing the Camera
Attaching the camera to a tripod
Attach a tripod to the screw hole used for
attaching a tripod on the bottom of the camera.
The tripod must be set up on a flat surface and its
screws tightened firmly by hand. Use a tripod
with screws of the following specifications.
 = 4.5 mm to 6 mm ( 3 /
16
in. to 1 /
4
in.)
Installing the camera in a high
location
To install in a high location, always attach using
the supplied wire rope to prevent the camera
from falling.
Make sure that the mounted orientation of the
camera is within ±45 degrees of the horizontal.
CAUTION
• Entrust installation to an experienced
contractor or installer when installing the
camera on ceilings or other high locations.
• When installing the camera in a high location,
be sure that the location and installation
components (excluding the supplied
accessories) are strong enough to support the
camera and the mounting bracket, and install
the camera securely. If the components are not
strong enough, the camera may fall and cause
an accident.
• Always install the supplied wire rope to prevent
the camera from falling.
• If you install the camera in a high location,
check periodically, at least once a year, to
ensure that the connection has not loosened. If
conditions warrant, make this periodic check
more frequently.
• Use the supplied screws or specified screws to
fix the wire rope and HDMI cable fixing plate.
The use of other screws may damage the unit.
Attaching the wire rope
1
Attach the wire rope to the ceiling.
2
Attach the wire rope to the wire rope
attachment hole on the back of the
camera.
SRG-XB25
1/4-20UNC
Ceiling
Hole for connecting cable
M3×8
(supplied)
Ceiling
Attach the
wire rope.