Sony HDVF-EL30 0.7" FHD OLED Viewfinder with 3.5" Display for 4K/HD Cameras User Manual
Page 10
10
Back
LAN (network) terminal (RJ-45)
Network communication and PoE power
supply are provided using the network cable
(category 5e or higher, shielded twist pair).
For more information on the connection,
refer to the instruction manual of the PoE
power supply device.
The LED on the left lights up in orange when
the network is connected by 1000BASE-TX,
or in green when connected by 100BASE-TX.
It is turned off when the network is
connected by 10BASE-T or the network is
disconnected.
The LED on the right flashes during data
transfer.
Factory settings for network
IP address: 192.168.0.100
Subnet mask: 255.255.255.0
Default gateway: 192.168.0.254
Name: CAM1
User name: admin
Password: Admin_1234
Note
When connecting this product to a network,
connect via a system that provides a
protection function, such as a router or
firewall. If connected without such
protection, security issues may occur.
AUDIO OUT terminal
Output LINE level to connect an audio
device.
AUDIO IN terminal
Input for commercially-available MIC or LINE
to connect an audio device.
Tip
Switch between MIC and LINE input, as
indicated on “Connecting to commercially-
available microphones etc.” (page 21).
12 V
(DC power input) terminal
Connect the AC adapter (supplied).
Note
Do not use any AC adapter other than the
supplied AC adapter. Otherwise, a fire or
malfunction may occur.
POWER lamp
Lights in green when the camera is
connected to an outlet using the supplied AC
adapter and power cord, or when power is
being supplied by connecting the camera
and PoE power supply device with a LAN
cable.
VISCA RS-232 IN terminal
Connect with an remote controller (not
supplied).
When you connect multiple cameras,
connect it to the VISCA RS-232 OUT terminal
of the previous camera in the daisy chain
connection.
VISCA RS-232 OUT terminal
When you connect multiple cameras,
connect it to the VISCA RS-232 IN terminal of
the next camera in the daisy chain
connection.
HDMI output terminal
Supplies the images as an HDMI video
signal.
Reset switch
Press the switch for 5 seconds or longer to
return to the factory default.