Sony HDVF-EL30 0.7" FHD OLED Viewfinder with 3.5" Display for 4K/HD Cameras - Manual (Page 19)

19
Connecting a single camera to a
computer via USB (SRG-XP1 only)
Note
Supply power using an AC adapter or PoE.
Connecting a single camera to a
single remote controller (not
supplied)
You cannot switch between VISCA over IP and
VISCA RS-232 with the camera. Communication
with the remote controller is possible by
connecting a network cable.
Select either VISCA over IP or VISCA RS-232 with
the remote controller. For details, see the
operating instructions of the remote controller.
Using VISCA over IP (LAN terminal)
Connecting a single camera to a remote
controller directly
* Use a cross network cable.
Using the VISCA RS-232 terminal
A remote controller can be connected via the
VISCA RS-232 terminal.
Note
The RM-IP500 cannot be connected due to lack
of a VISCA RS-232 terminal.
Connecting multiple cameras to a
single remote controller (not
supplied)
You cannot switch between VISCA over IP and
VISCA RS-232 with the camera. Communication
with the remote controller is possible by
connecting a network cable.
Select either VISCA over IP or VISCA RS-232 with
the remote controller. For details, see the
operating instructions of the remote controller.
Computer with USB port
USB 3.0 cable
(commercially available)
To USB port
VIDEO OUT
Network cable
(commercially available)
To LAN terminal
RS-232 cable
(supplied with RM-IP10)