Roland 6-Channel HD Video Switcher with Audio Mixer & PTZ Camera Control (1 RU) - Manual (Page 17)

17
Video Operations
Switching the Video
This selects video that is being input to the XS-62S, and outputs it
to the PGM/1 bus.
About the Operation Mode for Video Transitions
There are three operation modes for switching the PGM/1 bus
and PVW/2 bus: “PGM-PST mode,” “DISSOLVE mode,” and “MATRIX
mode.”
By factory default, the operation mode is set to the PGM-PST mode.
PGM-PST mode (p. 17)
You can select the preset video (the video to be output next) for
the PVW/2 bus, and after checking that video, output it to the
PGM/1 bus.
When you press the [TAKE] button, the PGM/1 bus video is
exchanged with the PVW/2 bus video.
DISSOLVE mode (p. 17)
You can select the video that you want to output, and
immediately output it to the PGM/1 bus.
MATRIX mode (p. 18)
You can individually select the video that is output to each bus
(PGM/1, PVW/2, AUX/3 buses).
Setting the operation mode
1. Select the [MENU] button 0 “MODE.”
2. Use the [VALUE] knob to select either “PGM-PST,”
“DISSOLVE,” or “MATRIX.”
3. Press the [VALUE] knob to apply the setting.
4. Press the [MENU] button to quit the menu.
Switching Using the PGM-PST Mode
You can select the preset video (the video to be output next) for
the PVW/2 bus, and after checking that video, output it to the
PGM/1 bus.
1. Press the [SW MODE] button several times to make
it light yellow.
The buses selected by the cross-point buttons (upper row) will be
the “PGM/1” and “PVW/2” buses.
2. Press a cross-point button (upper row) to select the
preset video (the video to be output next).
Lighted in red:
PGM/1 bus
Lighted in green:
PVW/2 bus
The channel you press is lit green. Alternatively, the preset video
appears in the PVW/2 section of the multi-view monitor.
MEMO
You use channels 7 and 8 to output a still image or a
monochrome picture (background color) (p. 19).
3. Press the [TAKE] button.
The video changes. At this time, the selected channel blinks red.
When the video has switched completely, the selected channel’s
cross-point button is lit red.
Switching Using the DISSOLVE Mode
You can select the video that you want to output, and
immediately output it to the PGM/1 bus.
1. Press the [SW MODE] button several times to make
it light yellow.
2. Press the cross-point button (upper row) that you
want to output to the PGM/1 bus.
The channel you pressed blinks green, and the video switches.
When the video has switched completely, the selected channel’s
cross-point button is lit red.
MEMO
5 You use channels 7 and 8 to output a still image or a
monochrome picture (background color) (p. 19).
5 The PGM/1 bus and PVW/2 bus output the same video.