Samsung 390 Series C24F390 24" 16:9 Curved FreeSync LCD Monitor - Manual (Page 35)

35
Eco Saving Plus
Reduce energy consumption compared to consumption at the maximum brightness level.
―
This option is not available when Bright is in Dynamic Contrast mode.
―
This menu is not available when Game Mode is enabled.
―
This menu is not available when Eye Saver Mode is enabled.
• Off : Deactivate the Eco Saving Plus function.
• Auto : The power consumption will automatically be reduced by about 10% over the current setting.
(The reduction of power consumption depends on the customer screen brightness condition.)
• Low : Saves up to 25 % energy compared to the maximum brightness.
• High : Saves up to 50 % energy compared to the maximum brightness.
Off Timer
Off Timer : Turn on Off Timer mode.
Turn Off After : The off timer can be set within a range of 1 to 23 hours. The product will automatically
power off after the specified number of hours.
―
This option is only available when Off Timer is set to On .
―
For products for the market in some regions, the Off Timer is set to automatically activate 4 hours after the
product powers on. This is done in accordance with power supply regulations. If you do not want the timer
to activate, go to
MENU System and set Off Timer to Off .
PC/AV Mode
Set PC/AV Mode to AV . The picture size will be enlarged.
This option is useful when you view a movie.
• Set to PC when connected to a PC.
• Set to AV when connected to an AV device.
―
This function does not support Analog mode.
―
Supplied for the wide models only such as 16:9 or 16:10.
―
If the monitor is in HDMI / DisplayPort mode and the screen says Check Signal Cable or power saving mode
activates, press the JOG button to display the function-button screen and then select the icon. You
can select PC or AV .
Source Detection
Select either Auto or Manual as the method to recognize input signal.
Key Repeat Time
Control the response rate of a button when the button is pressed.
Acceleration , 1 sec , or 2 sec can be selected. If No Repeat is selected, a command responds only once
when a button is pressed.