Canon PowerShot SX540 HS - Manual (Page 119)

119
Before Use
Basic Guide
Advanced Guide
6
Playback Mode
7
Wi-Fi Functions
8
Setting Menu
9
Accessories
10
Appendix
Index
1
Camera Basics
2 Auto Mode /
Hybrid Auto Mode
3
Other Shooting Modes
4
P Mode
5
Tv, Av, and M Mode
Saving Images to a Connected Computer
Connect to your access point via Wi-Fi as follows.
Also refer to the access point user manual.
Confirming Access Point Compatibility
Confirm that the Wi-Fi router or base station conforms to the Wi-Fi
standards in “Camera” (= 178).
Connection methods vary depending on whether the access point
supports Wi-Fi Protected Setup (WPS) (= 120) or not (= 122). For
non-WPS access points, check the following information.
● Network name (SSID/ESSID)
The SSID or ESSID for the access point you use. Also called the
“access point name” or “network name”.
● Network authentication / data encryption (encryption method/
encryption mode)
The method for encrypting data during wireless transmission. Check
which security setting is used: WPA2-PSK (AES), WPA2-PSK
(TKIP), WPA-PSK (AES), WPA-PSK (TKIP), WEP (open system
authentication), or no security.
● Password (encryption key / network key)
The key used when encrypting data during wireless transmission. Also
called the “encryption key” or “network key”.
● Key index (transmit key)
The key set when WEP is used for network authentication / data
encryption. Use “1” as the setting.
● If system administrator status is needed to adjust network
settings, contact the system administrator for details.
● These settings are very important for network security. Exercise
adequate caution when changing these settings.
Configuring the Computer for a Wi-Fi Connection
(Windows Only)
On a computer running Windows, configure the following settings before
connecting the camera to the computer wirelessly.
1
Confirm that the computer is
connected to an access point.
● For instructions on checking your network
connection, refer to the computer user
manual.
2
Configure the setting.
● Click in the following order: [Start] menu
► [All Programs] ► [Canon Utilities] ►
[CameraWindow] ► [Wi-Fi connection
setup].
● In the application that opens, follow the
on-screen instructions and configure the
setting.
● The following Windows settings are configured when you run the
utility in step 2.
- Turn on media streaming
This will enable the camera to see (find) the computer to access
via Wi-Fi.
- Turn on network discovery
This will enable the computer to see (find) the camera.
- Turn on ICMP (Internet Control Message Protocol)
This allows you to check the network connection status.
- Enable Universal Plug & Play (UPnP)
This will enable network devices to detect each other
automatically.
● Some security software may prevent you from completing the
settings as described here. Check the settings of your security
software.