Yamaha CVP-705B - Manual (Page 19)

CVP-709/CVP-705 Owner’s Manual 19
Sta
rting
U
p
1
Turn down the [MASTER VOLUME] dial to “MIN.”
2
Press the [] (Standby/On) switch to turn the power on.
The display and the power indicator located below the left end of the keyboard
lights up. Adjust the volume as desired while playing the keyboard.
3
Press and hold the [] (Standby/On) switch for about a second to turn the power
off.
CAUTION
Even when the [] (Standby/On) switch is in standby status, electricity is still flowing to the instrument at the
minimum level. Remove the electric plug from the outlet when the instrument is not to be used for extended
periods of time, or during electrical storms.
NOTICE
While recording or editing, or while a message is displayed, the power cannot be turned off even if you press the
[
] (Standby/On) switch. If you want to turn off the power, press the [] (Standby/On) switch after recording,
editing, or after the message has disappeared. If you need to force-quit the instrument, hold down the
[
] (Standby/On) switch for longer than three seconds. Note that the force-quit operation might cause data loss
and damage to the instrument.
Auto Power Off function
To prevent unnecessary power consumption, this instrument features an Auto Power Off function that
automatically turns the power off if the instrument is not operated for a specified period of time. The
amount of time that elapses before the power is automatically turned off is approximately 30 minutes by
default; however, you can change the setting (page 22).
NOTICE
Any data which is not saved via the Save operation will be lost if the power automatically turns off. Make sure to save
your data before this happens.
Turning On/Off the Power
Disabling Auto Power Off (simple method)
Turn the power on while holding down the lowest key on the keyboard. An “Auto power off disabled” message
appears briefly and Auto Power Off is disabled.
The power indicator
lights up.
+
A-1