Yamaha CVP-705B - Manual (Page 104)

CVP-709/CVP-705 Owner’s Manual 104
CVP
-709 (G
ra
n
d
p
ia
n
o ty
pe) A
ssem
bly
5
Plug the power cord into the [AC IN] jack.
6
Rotate the adjuster until it comes in firm
contact with the floor surface.
7
Attach the headphone hanger.
Attach the headphone hanger using two thin screws (4 x
10 mm) as shown in the illustration.
Right leg on the bottom of the main unit, when viewed from front.
After completing the assembly, please check the following.
• Are there any parts left over?
→ Review the assembly procedure and correct any errors.
• Is the instrument clear of doors and other movable
fixtures?
→ Move the instrument to an appropriate location.
• Does the instrument make a rattling noise when you
shake it?
→ Tighten all screws.
• Does the pedal box rattle or give way when you step on
the pedals?
→ Turn the adjuster so that it is set firmly against the floor.
• Are the pedal and power cords inserted securely into
the sockets?
CAUTION
When moving the instrument, always hold the bottom of the
main unit. Do not hold the key cover or top portion. Improper
handling can result in damage to the instrument or personal
injury.
Transporting
If you move to another location, you can transport the
instrument along with other belongings. You can move the
unit as it is (assembled) or you can disassemble the unit down
to the condition it was in when you first took it out of the box.
Transport the keyboard horizontally. Do not lean it up against
a wall or stand it up on its side. Do not subject the instrument
to excessive vibration or shock. When transporting the
assembled instrument, make sure all screws are properly
tightened and have not been loosened by moving the
instrument.
CAUTION
If the unit creaks or is otherwise unsteady when you play on
the keyboard, refer to the assembly diagrams and retighten
all screws.
Do not hold
here.
Do not hold here.