Yamaha CVP-705B - Manual (Page 107)

CVP-709/CVP-705 Owner’s Manual 107
CVP
-70
9 A
ssem
bl
y
Pass the pedal cord from under unit D to the backside of
the main unit.
Place unit F on the bracket of unit D.
Attach unit F to unit D using three screws M.
7
Connect the pedal cord.
Attach unit G using two screws N.
(CVP-709PWH) Attach two caps K.
8
Insert the AC power cord plug into the [AC
IN] jack.
9
Rotate the adjuster until it comes in firm
contact with the floor surface.
10
Attach the headphone hanger.
Attach the headphone hanger using two screws P as
shown in the illustration.
M
Insert the pedal cord plug into the
pedal connector.
Insert the pedal cord securely until
the metal part of the cord plug
disappears from view. Otherwise,
the pedal may not function
properly.
Pass the pedal
cord between
units D and E. Align the pedal cord into the
groove on unit D, then install
the cover onto the groove
correctly.
Correct
Incorrect
K
CVP-709B
CVP-709PE
CVP-709PWH
G G
N
N
After completing the assembly, please check the following.
• Are there any parts left over?
→ Review the assembly procedure and correct any errors.
• Is the instrument clear of doors and other movable
fixtures?
→ Move the instrument to an appropriate location.
• Does the instrument make a rattling noise when you
shake it?
→ Tighten all screws.
• Does the pedal box rattle or give way when you step on
the pedals?
→ Turn the adjuster so that it is set firmly against the floor.
• Are the pedal and power cords inserted securely into
the sockets?
P