ProSoft Technology RLX2-IFH9E - Manual (Page 52)

Diagnostics and Troubleshooting RLX2-IFHxE ♦ Industrial Wireless
User Manual Industrial Frequency Hopping Ethernet Radios
Page 52 of 81 ProSoft Technology, Inc.
May 28, 2014
To detect the radio channel noise level for a particular radio:
1. Open the U TILITIES menu, and then choose IFHE S PECTRUM A NALYZER .
2. Select the radio by IP ADDRESS , and then click O PEN .
3. ControlScape FH then scans within the radio, and measures the noise
within the frequency band. This data can help determine if there is a
signal that is interfering with radio communications. The radio continues
to periodically scan its frequency band until you click C
LOSE , or you select
a different radio to scan.
Note: The information in this dialog box is valid only for radios accessed through a wired Ethernet
network. Scans for radios only over the RF network may not be accurate.
Note: Radio network communications are interrupted while the Spectrum Analyzer is active.
Normal communication resume when you close the dialog box.
3.3.3 RLX2-IFHE Spectrum Analyzer Dialog Box
The Spectrum Analyzer Dialog Box opens when you choose Utilities > IFHE
Spectrum Analyzer. Use this dialog box to help diagnose network issues.
Note: The information in this dialog box is valid only for radios accessed through a wired Ethernet
network. Scans for radios only over the RF network may not be accurate.
Note: Radio network communications are interrupted while the Spectrum Analyzer is active.
Normal communication resumes when you close the dialog box.
The fields in the dialog box are:
 IP Address: The IP address for the radio to test. Enter an IP address directly,
or click Select Radio to choose a radio.