Planning the physical installation – ProSoft Technology RLX2-IFH9E User Manual
Page 33
RLX2-IFHxE ♦ Industrial Wireless
Start Here
Industrial Frequency Hopping Ethernet Radios
User Manual
ProSoft Technology, Inc.
Page 33 of 81
May 28, 2014
When to Re-Configure Radios
All radios must be configured before being installed in a network. In general, after
the radios are functioning in a network, they do not need to be re-configured if
the network changes. The program alerts you when the radios need to be
configured (radio type, IP address, etc), as illustrated below:
Reconfiguring a Remote Radio
To reconfigure the Remote radio(s), click Configure Radio on the Radio
Configuration dialog box.
Repeat these steps for each Remote radio on your network.
After you configure all the radios, the graphical layout appears as follows:
1.7
Planning the Physical Installation
A network's performance is affected by attributes specific to the installation site.
Consider the following requirements, where possible, to optimize your network
installation:
Design the network to use less than 2048 radios (per network).