Viewing the next 20 commands, Returning to the main menu, Led status indicators – ProSoft Technology MVI46-DNP User Manual
Page 52: Status, Indicators

MVI46-DNP ♦ SLC Platform
Diagnostics and Troubleshooting
Master/Slave Communication Module
Page 52 of 143
ProSoft Technology, Inc.
August 23, 2007
Viewing the Next 20 Commands
Press [+] to display data for the next 20 commands.
Viewing the Next Page of Commands
Press [N] to display the next page of commands.
Returning to the Main Menu
Press [M] to return to the Main Menu.
4.2
LED Status Indicators
The LEDs indicate the module's operating status as follows:
ProSoft
Module
Color Status Indication
On
Data is being transferred between the module and a remote
terminal using the Configuration/Debug port.
CFG Green
Off
No data is being transferred on the Configuration/Debug port.
On
Data is being transferred by the module on Port 1.
P1 Green
Off
No data is being transferred on the port.
On
Data is being transferred by the module on Port 2
P2 Green
Off
No data is being transferred on the port.
On
The MVI module is working normally.
APP Amber
Off
The MVI module program has recognized a communication
error on one of its ports.
On
The LED is on when the module is performing a write operation
on the backplane.
BP ACT
Amber
Off
The LED is off when the module is performing a read operation
on the backplane. Under normal operation, the LED should blink
rapidly on and off.
Off
The card is not receiving any power and is not securely plugged
into the rack.
Green
The module is operating normally.
OK Red/
Green
Red
The program has detected an error or is being configured. If the
LED remains red for over 10 seconds, the program has probably
halted. Power down and remove the card from the rack and re-
insert the card, then power up the rack.
Off
The battery voltage is OK and functioning.
BAT Red
On
The battery voltage is low or battery is not present. Allow battery
to charge by keeping module plugged into rack for 24 hours. If
BAT LED still does not go off, contact the factory, as this is not a
user serviceable item.
During module configuration, the OK LED will be red and the APP and BP ACT
LEDs will be on. If the LEDs are latched in this mode for a long period of time,
look at the configuration error words in the configuration request block.