ProSoft Technology MVI46-DNP - Manual (Page 10)

MVI46-DNP ♦ SLC Platform Start Here
Master/Slave Communication Module
Page 10 of 143 ProSoft Technology, Inc.
August 23, 2007
2 Align the module with the top and bottom guides, and slide it into the rack
until the module is firmly against the backplane connector.
3 With a firm but steady push, snap the module into place.
4 Check that the holding clips on the top and bottom of the module are securely
in the locking holes of the rack.
5 Make a note of the slot location. You will need to identify the slot in which the
module is installed in order for the sample program to work correctly. Slot
numbers are identified on the green circuit board (backplane) of the SLC
rack.
6 Turn power ON.
Note: If you insert the module improperly, the system may stop working, or may
behave unpredictably.