ProSoft Technology MVI69E-MBS - Manual (Page 140)

Reference MVI69E-MBS ♦ CompactLogix Platform
User Manual Communication Module
Page 140 of 162 ProSoft Technology, Inc.
January 6, 2014
Offset Description
23 Port 2 Errors Sent: Total number of message errors sent out of the port.
24 Port 2 Errors Received: Total number of message errors received on the port.
25 Read Block Count: Total number of read blocks transferred from the module to the
processor.
26 Write Block Count: Total number of write blocks transferred from the processor to
the module.
27 Parse Block Count: Total number of blocks successfully parsed that were received
from the processor.
28 Event Command Block Count: Total number of Event Command blocks received
from the processor.
29 Command Control Block Count: Total number of Command Control blocks received
from the processor.
30 Error Block Count: Total number of block errors recognized by the module.
31 Port 1 Current Error: For a slave port, this field contains the value of the current
error code returned. For a master port, this field contains the index of the currently
executing command.
32 Port 1 Last Error: For a slave port, this field contains the value of the last error code
returned. For a master port, this field contains the index of the command with an
error.
33 Port 2 Current Error: For a slave port, this field contains the value of the current
error code returned. For a master port, this field contains the index of the currently
executing command.
34 Port 2 Last Error: For a slave port, this field contains the value of the last error code
returned. For a master port, this field contains the index of the command with an
error.
7.4.11 Set Port and Command Active Bits Block
Block 9500: Set Port and command active bits
This block enables and disables ports, as well as individual Master commands
for a port.
Block 9500: Request from Processor to Module
Offset Description
0 Write Block ID: 9500 to set port and command enable/disable state
1 Port 1 active state: 0=disabled, 1=enabled
2-21 Command enable bits for Port 1 commands (0=disabled, 1=enabled)
22 Port 2 active state: 0=disabled, 1=enabled
23-42 Command enable bits for Port 2 commands (0=disabled, 1=enabled)
43 to (n-1) Spare
Where n = 60, 120, or 240 depending on the Block Transfer Size parameter.