PLANET GRT-501 - Manual (Page 35)

GRT-501 G.SHDSL.bis Bridge Router User’s Manual
- - 34
Step 2.
Configured 0.0.0.0 will allow all hosts on
Internet or LAN to access the router.
Leaving blank of trust host list will cause
blocking all PC from WAN to access the
router. On the other hand, only PC in LAN
can access the router.
If you type the excact IP address in the
filed, only the host can access the router.
Click Finish to finish the setting
Step 3.
The browser will prompt the configured parameters and check it before writing into EPROM.
Press Restart to restart the gateway working with the new parameters and press Continue to setup other
parameters.
4.4.2 SNMP
Simple Network Management Protocol (SNMP) provides for the exchange of messages
between a network management client and a network management agent for remote
management of network nodes. These messages contain requests to get and set variables
that exist in network nodes in order to obtain statistics, set configuration parameters, and
monitor network events. SNMP communications can occur over the LAN or WAN
connection.
The router can generate SNMP traps to indicate alarm conditions, and it relies on SNMP
community strings to implement SNMP security.
This router support both MIB I and MIB II.
Web UI Configuration