PLANET ADN-4100 - Manual (Page 91)

80
Note: You can enter the gateway IP address of the device in the Use
Gateway IP Address field or set the User Interface, but cannot apply the two
settings at the same time.
3.3.11.2
74B
Policy Route
Choose Advanced > Routing and click Policy Route. Click Add and the page
as shown in the following figure appears:
In this page, you can select the interfaces on your device that use RIP of the
protocol used.
If you enable RIP, the device communicates with other devices using the routing
information protocol (RIP).Click Apply to save the settings.