PLANET ADN-4100 - Manual (Page 31)

20
Field Description
ATM PVC CONFIGURATION
VPI
Virtual Path Identifier (VPI) is the virtual path between two
points in an ATM network. Its value range is from 0 to
255.
VCI
Virtual Channel Identifier (VCI) is the virtual channel
between two points in an ATM network. Its value range is
from 32 to 65535 (0 to 31 is reserved for local
management of ATM traffic).
Service Category
Select UBR with PCR, UBR without PCR, CBR, Non
Realtime VBR, or Realtime VBR from the drop-down list.
Peak Cell Rate
Set the maximum transmission rate of the cell in ATM
transmission.
Sustainable Cell
Rate
Set the minimum transmission rate of the cell in ATM
transmission.
Maximum Burst
Size
Set the maximum burst size of the cell in ATM
transmission.
CONNECTION TYPE
Protocol
Select PPP over ATM (PPPoA), PPP over Ethernet
(PPPoE), MAC Encryption Routing (MER), IP over
ATM (IPoA), Bridging or PPTP from the drop-down list.
Encapsulation
Mode
Select LLC or VCMUX from the drop-down list. Usually,
you can select LLC.
802.1Q VLAN ID
If you enter a value, packets from the interface is tagged
with the set 802.1q VLAN ID. Its value range is 0-4094,
while 0 indicates to disable this function.
Enable Proxy Arp Check this to enable proxy arp.
Protocol Type You can select the IPv4,IPv6 or IPv4&6
NETWORK ADDRESS TRANSLATION SETTINGS
Enable NAT
Select or deselect the check box to enable or disable the
NAT connection.
NAT Type
Select Symmetric Nat or Full cone Nat from the
drop-down list
Enable WAN
Service
Select or deselect the check box to enable or disable the
WAN connection.