PLANET ADN-4100 - Manual (Page 15)

Rear Panel
The following table describes the interfaces and buttons of the device.
Interface/Button Description
LINE
RJ-11 interface, for connecting the interface of the
telephone set through the telephone cable.
LAN1,LAN2,
LAN3,LAN4
RJ-45 interface, for connecting the Ethernet interface of a
computer or an Ethernet device.
POWER
Power interface, for connecting the interface of the power
adapter.
RESET
Restore to factory defaults. To restore factory defaults,
keep the device powered on, push a paper clip into the
hole to press the button for over 3 seconds and then
release.
WPS/ WLAN
Press the button and hold it for 1 second, to
enable/disable WLAN.
Press the button and hold it for 3 or more than 3
seconds, to initialize WPS negotiation.
ON/OFF Power switch, power on or off the device.
1.3
5B
System Requirements
Recommended system requirements are as follows:
A 10Base-T/100Base-TX Ethernet card is installed on your PC.
A hub or switch is available for connecting one Ethernet interface on the
device and several PCs.
Operating system: Windows 7 \ Vista \ XP \ 2008 server \ 2003 server \
2000 \ ME \ 98SE.
4