PLANET VIP-000 - Manual (Page 84)

VIP User ’s Manual
Command Line Interface 70
7.10.1 Common Coding Profile Configuration Commands
set coding profile_id coding_type coding_type
Syntax description
coding_type Type of the codcc as defined in the following table.
Parameter Description
g711_mu G.711 PCM u-law coding
g723_53 G.723.1 5.3 kbps coding
g723_63 G.723.1 6.3 kbps coding
g729ab G.729 annex A, annex B 8kbps coding
fax_t38 Fax Relay in T.38 mode
Note: Modification will not take effect till save and next reboot.
set coding profile_id cp_tone_detect {on | off}
This command is used to specify a secondary level of control of call progress tone detection. If the
call progress detection control for a telephony port is set to "As per coding profile" (refer to com-
mand
“ set port port cp_tone_det_ctr l ”), this parameter determines if detection is to be enabled or
not.
Syntax description
on Enable call progress tone detection.
off Disable call progress tone detection.
set coding profile_id fax_tone_detect {on | off}
This command is used to specify a secondary level of control of V.21 fax tone detection. If the fax
tone detection control for a telephony port is set to "As per coding profile" (refer to command
“ set
port port fax_tone_det_ctrl ”), this parameter determines if detection is to be enabled or not. For a
voice coder, fax tone detection has to be enabled, otherwise, telephony port never switches to fax
mode while the voice coder is active. For a fax profile it does not matter if the fax tone detection is
enabled or disabled.
Syntax description
on Enable V.21 fax tone detection.
off Disable V.21 fax tone detection.
set coding profile_id usage {voice | fax} {on | off}
Syntax description