PLANET VIP-000 - Manual (Page 48)

VIP User ’s Manual
Configuring VIP from a Web Browser 34
1. Display Name : The default string is “Customer”.
This field is to set the display name information that is carried in the H.323 setup messages. Up to 48
characters can be entered.
2. Terminal Type : The default value is 60.
This field is to set the H.245 terminal type, which is used as part of the master/slave determination
process of H.245. Typically, setting a value of less than 50 will force slave operation, and a value of
greater than 200 will force the master operation.
3. RTP Port Base : The default value is 30000.
This field is to select the starting port number for assignment of RTP and RTCP ports. According to
the H.323 specification, RTP port number should be even in value, and the RTCP port number should
be one greater than the RTP port. Typically, numbers from 0 to 1023 are reserved on most systems.
4. Outgoing Fast Start : The default setting is off.
This field is to enable or disable the Faststart mode on the outgoing side of the link.
5. Incoming Fast Start : The default setting is off.
This field is to enable or disable the Faststart mode on the incoming side of the link.
6. NAT_Call Mode : default is ON:
Enables calls from remote sites, which use NAT routers with private IP networks behind.
7 . Default DTMF Mode : H323 V2 Signal or IMTC. The default is H323 V2 Signal
8 . DNS IP Address :
Specify DNS server IP address; this parameter is required while DDNS client is enabled in VIP.
9. Call Signal Port :
Allows users to select TCP port which H.225 listens for incoming call setup request. (CLI only)
10. Local Alert :