PLANET VIP-000 - Manual (Page 18)

VIP User ’s Manual
Overview 4
Reset Button
There is a push button located behind a small hole next to the SYSTEM LED. This button allows
you to reset VIP or force VIP to enter firmware upgrade mode.
Reset
Push a small, stiff object into the hole until the SYSTEM LED stops blinking, then release the but-
ton.
Force firmware download mode:
Powering on the gateway while pressing down the button for 5 seconds forces VIP to enter
download mode
1.5 Rear Panel
The rear panel of VIP-000 has two slots allowing the installation of up to two Telephony-Interface-
Modules (TIM) . Each module is equipped with 4 telephony interface ports. Depending on the type
of the telephony interface module, the telephony interface ports may be connected to telephony de-
vices, such as PBX, KTS, and telephone sets of central office. VIP-200 equips two FXS ports for
and VIP-400 equips with two FXO and two FXS ports. In addition to the TIM slots (ports), there is
an AC power receptacle and a power switch (power adapter: VIP-200/400) on the rear panel.
Slot A Slot B
Figure 1-4 VIP-000 Rear Panel
Figure 1-5 VIP-200 Rear Panel
Figure 1-6 VIP-400 Rear Panel
Figure 1-7 VIP-400FS Rear Panel
4 3 1 2 2 1
50~60
Hz
90~240V
AC
SLOT A
ELITE-FXO ELITE-FXS
SLOT B