PLANET WAP-7500 - Manual (Page 55)

Figure 42 SSH
Enter the user name and password (Default user name/ password: admin/password) respectively,
you will see “DEVICE123456>”, which is the name of WAP-7500;
Enter “help” command to get setting information; alternatively, you can refer to Appendix C. SSH
Settings for details.
5.6.2 SNMP
The WAP-7500 supports SNMP management. Set the SNMP parameters and obtain MIB file before
remote management.
From “Remote Management” in “Management”, set the parameters for SNMP:
- Enable SNMP by checking “Enable”;
-
Specify the “Read Community Name”, “Write Community Name” and “IP Address to
Receive Traps ”
- Hit
“Apply” to save settings.
Obtain MIB file via FTP:
- Enter
ftp 192.168.1.1 , username (Default: admin) and password (Default: password);
- After successful login, enter command “get bridge.mib”, the information will as below and
then bridge.mib file is obtained.
Page 55