PLANET WAP-7500 - Manual (Page 34)

Setting it too low may result in poor network performance. Leave it at its default of 2346 is
recommended.
Beacon Interval
Specify the frequency interval to broadcast packets. Enter a value between 20 and 1000.
Distance in Meters
To decrease the chances of data retransmission at long distance, WAP-7500 can auto adjust
proper ACK timeout value by specifying distance of the two nodes. Default distance is 10km.
This will be only useful in CSMA mode.
TDM Coordination Time Slice
Specify the time slice of TDM Coordination. It allows a certain amount of time (in ms) that data will
transmit to each other before it moves to the next user. This is a repetitive cycle.
Note:
We strongly recommended you leave most advanced settings at their defaults except
Distance in Meters; any modification on them may negatively impact the performance of
your wireless network.
4.2 Peer-to-Peer Links
Open “Peer-to-Peer Setup” in “Wireless”. Peer-to-Peer Links allow establishing PTP or PTMP
connectivity with as most eight remote wireless devices, this feature only available under Peer-to-Peer
(CSMA) mode. Select “RF1”, and input the MAC addresses of radio cards from remote unit
respectively.
Furthermore, you may restrict the uplink speed of each peer for optimal bandwidth control.
Page 34