PLANET WAP-7500 - Manual (Page 29)

Country/Region
For the available radio bands vary from country to country, the working channels used are
different.
Ethernet Data rate
Specify the transmission rate of data.
Spanning Tree Protocol (STP)
Spanning Tree Protocol is a link management protocol for bridges which provides path redundancy
while preventing loops in a network. STP allows only one active path at a time between the
bridges but establish the redundant link as a backup if the initial link fails.
STP Forward Delay
STP Forward Delay is the time spent in detecting and learning network tree topology state before
entering the forward state. Default time value is 1 sec. Select Normal if you would like to modify
the parameter (4-30 seconds).
VLAN
By enabling VLAN function, the WAP-7500 is able to operate with the VLANs set up on your VLAN
network.
Management VLAN ID
You need to define a VLAN ID for your WAP-7500 to be recognized by the VLAN network. The
VLAN ID corresponds to the local ID on your Switch.
System Monitor
By enabling System Monitor, when system errors take place and are detected, a
software-triggered watchdog reset occurs to resume normal operation.
Link Aggregation
Link Aggregation combines two physical network links into a single logical link for increased
bandwidth. Besides, it provides load balancing.
IP Address
If you select “Manual”, you have to specify a static IP address, subnet mask, default gateway and
DNS server for your local area network which connects to the LAN port of WAP-7500. Make sure
the specified IP address is unique on your network in order to prevent IP conflict.
DHCP Client
Enable DHCP client to allow the DHCP server within your local area network to assign an IP
Page 29